Ratchet 10" X 1" Bolt Eye-Eye Ratchet 10" barrel 7/8" thread Eye-Eye. Eye for 1" bolt. 13,000 lbs working load max.
Decal Kit SC or Stationary Decal kit for a self-contained or stationary compactor including the power unit
Siemens Starter for 6-18 FLA Starter for motors with full load amps between 6-18 for the voltage used. 120VAC Coil. This starter is the universal size for 5HP/3Ph motors. Also 3/4HP/1Ph and 1HP/1Ph motors. Starter Selection Chart
Ratchet 12" 1-3/8" Bolt Jaw-Jaw Ratchet 12" barrel, 1-3/8" thread, Jaw-Jaw. Jaw opening for 1-1/4" plate, 1" bolt. 28,000 lbs working load max. 22" closed centers, 34" extended. Replacement bolts are 1" x 4".
Pump Gear Alum 11.5 GPM 3/4" Shaft Pump Gear Aluminum 11.5 GPM 3/4" Shaft. This pump has 12MB suction port. OEM pumps often have 14MB with a 1" suction pipe. If you are unsure, order the adaptor below to adapt the 1" pipe to the pump inlet.
PSI Waste Keypad Panel Door Strike with 15' whip. Keypad Panel Door Strike with 15' whip. User Sheet Keypad Manual
PSI Waste Panel: 10HP Inverter, Versa-Pak WD Panel: 10HP Inverter, Versa-Pak WD for Compactor Power Unit with Cart Dumper, Panel Size 20 X 20 X 12. Manual Versa-Pak.net Support Page Branch Circuit ***Actual product may differ from product shown.
Inverter 5HP 1Ph Fuji with parameters set and control wires pulled. Inverter 5HP 1Ph Fuji with parameters set and control wires pulled.
Nachi Valve, Directional Control D05 2 Position P-B Directional Control Valve, D05 2 Position P-B (H3Z). Often used on BJ Atlantic and Hydrolec power units. Directional Valve Types
Nachi Valve, Directional Control D08 Tandem Center Directional Control Valve, D08 Tandem Center Often used on pre-crushers, horizontal balers, etc. Directional Valve Types
Pump Vane V20 16.5 GPM 3/4" Shaft Pump Vane V20 16.5 GPM 3/4" Shaft. SAE A flange, 1-1/4" inlet, 3/4" outlet. Often used with 15HP motors. The outlet can be rotated to (4) different positions in increments of 90 degrees.
Suction Strainer 1" 10 GPM Suction Strainer 1" NPT, 10 GPM (Use a reducer to size down to 3/4" NPT. See link below.)
